The CL-131S electrostatic powder manual coating equipment with the

COLO-07 manual powder gun is ideally suited for manual coating of objects in larger series.

Theprocess of the coating is like this :thepowder is fluidized in thepowder hopper. The injectors transport thepowder through the hoses tothe guns . The guns spray a powder/airmixture onto the workpieces.

Typical characteristics

- Processing the powder from the fluidized powder hopper

- Quick and simple color change

- Supplied ready for use

- Available with one or two guns (extensible)

Technical Data

Electrical data

Power range                                   100-240V

Frequency                                     50HZ /60HZ

Temperature range in use                      -10 ℃+50 ℃

Powder Gun

Gun weight:    ^^^                    500G

Rated output voltage ^…                      24VDC

Input voltage     ^^…                       - 200kv

Maximum output current  ^…                   180Ua(max)

Maximum output voltage^^                   0-100KV (  adjustable)    

Maximum powder injection :^…                    600g/min

Polarity ^^^                                negative (-)   

Pneumatic data

Maximum input-air pressure ^^..                 10kg/cm

Optimum input-air pressure^..                        6kg/cm

Minimum input-air pressure   ^                      4kg/cm

Maximum water vapor content or compressed air …..      1.4g/N m3  

Maximum oil vapor content of compressed air   ^..     0.1ppm

Maximum compressed-air consumption^…            13.2 m3/h

Dimensions

Manual coating equipment-structure

1 control unit               2 Manual powder gun

3 injector                   4 Mobile frame with hand rail (trolley)

5 Fluidized powder hopper   

8 Filter unit

9 Gun holder               

11 Hose holder              12 Hose holder

13 Rubber wheel

WARNING

--INSTALLATION

→Propery ground all equipment in the spray area to an earth ground and maintain this ground

→Remove all containers of volatiles from the spray area

→Establish and maintain a grounded area for the spray operator

→The gun of x series must be connect to x control unit

→OPERATION

→The operator should hold the gun in his bare hand

→If gloves are worm ,the palm should be out to assure skin to metal contact

→The operator should wear shoes with conductive shoes e.g leather

Rubber shoes are not conductive .

→Ground the tip of the gun before cleaning or changing nozzles.

→When the gun is not in use , it should be hung so that the nozzle is within four inches of a grounded conductor

→The operator should wear a filter-type respiator anytime he is exposed to dusty conditions

→High pressure powder many cause injury ,Keep the rear switch  "off" position in no –use condiction

→MAINTENANCE

→Make a periodic confirmation of grounding to earh of all equipment in the spray area .

→Exercise good housekeeping practices , do not allow dirt or powder to accumulate on the feeder /powder unit , cable or gun.

→Keep the cabinet door

PERSONNEL

→Use saop and water to remove powder from the skin washing with solvents can cause reactions resulting in allergies and disourders.

→Wash hands before eating and smoking.

→Do not use compressed air to blow poder off the hands and clothing.

This practice may result in damage to the ear drums or eyes.

2. INSTALLATION

→Connects the control units MAIN AIR to MAIN AIR(REGULATOR) output unit with air hose

→Connects the control unit DOSING AIR to INJECTOR with air hose

→Connects the FLUIDIZING AIR (REGULATOR )output unit to HOPPER with air hose

→Connects the control unit AUXILIARY AIR to GUN with air hose

→Connects the POWDER HOSE to INJECTOR

→Connects the GUN CABLE to CONTROL UNIT with air hose

→Connects  ground connection cable from ground nut to the booth and trolly

→Connect main powder cable